Velleman CAMIP5N Notice D'emploi page 18

Log
The log shows an overview of everyone who accessed the IP camera. It is cleared when rebooting the system.
Back
Use this option to return to the For Visitor or For Operator page layout.
9. Additional user information
9.1 Password
Default, the administrator login is admin without a password. To enhance security, a new administrator
password should be set as soon as possible (see §8.5 under For Administrator layout – Users Settings).
If the login or password of the administrator(s) are forgotten or corrupt, the system can be reset to factory
defaults (admin, no password) by pressing and holding the RESET button at the bottom of the camera for
about 5 seconds.
9.2 WiFi
1. Refer to the user manual of your wireless router to obtain network information e.g. SSID, Channel,
Security, authentication, encryption...
2. Use previously obtained information to configure your CAMIP5N via a fixed network cable (For
Administrator – Wireless LAN settings).
3. Reboot the CAMIP5N.
4. Wait at least 30 seconds before unplugging the network cable. Then unplug the power supply.
5. Re-insert the power plug.
After about 30 seconds, the camera should be up and running in WiFi mode.
9.3 Connect the camera on an ADSL network
1. Connect the camera to a PC. The easiest way is to use a router. If nPo router is available, you must use a
cross cable (not incl.) to connect the CAMIP5N directly to the PC's 8P8C (RJ45) port and set the IP
addresses on PC and camera manually.
2. Configure the camera with the IP camera tool (see §8.1).
3. Log on to the camera as administrator and configure ADSL settings (user name + password).
4. Configure the DDNS Service Settings and click Submit. The camera reboots.
5. Connect the camera directly to the ADSL modem. It is now available through the internet by entering the
domain name in your internet browser.
Note: set the option Report ADSL IP by mail under Mail Service Settings to receive the camera's IP
address by mail.
9.4 Connect the camera via a router
1. Connect the camera to the LAN and configure the camera with the IP camera tool (see §8.1).
2. Log on to the camera as administrator and configure DDNS Service Settings.
3. Click Submit to reboot the camera.
The camera is now available through the internet by entering the domain name in your internet browser.
V. 02 – 22/05/2012
CAMIP5N
18 ©Velleman nv