Velleman CAMIP5N Notice D'emploi page 15

11. When the camera has restarted, open Device Info on the administrator panel, and check if the DDNS
status is successful.
Note: If not, double-check if you have entered the correct host name, user name, and password. Correct if
necessary.
Mail Service Settings
Note: these settings only take effect when the option Send Mail on Alarm is checked in the Alarm Service
Settings menu (see below).
• Fill in a senders e-mail address in the Sender field. This is the mailbox from which the mails will be sent.
• Fill in up to 4 receivers mail addresses. When an alarm condition occurs, mail is sent out to these
addresses.
• Fill out all SMTP data related to the sender's mailbox. When authentication for the mailbox is required,
check the checkbox and enter user name and password in the appropriate fields.
• When the Report Internet IP by Mail box is checked, a mail is sent whenever a camera comes online
(e.g. after reboot) or a change in IP address occurred. Make sure the port is correctly mapped to the router.
• Press Submit to store the data before performing a 'mail test'. Following error messages may pop-up:
Cannot connect to the server
o
Check network cabling and settings.
Network error. Please try later.
o
Check network cabling and settings.
Server error.
o
Check the server.
Incorrect user or password.
o
Make sure to enter the right user name and password.
The sender is denied by the server.
o
Check whether the user needs authentication.
The receiver is denied by the server.
o
Could be due to anti-spam settings of the server.
The message is denied by the server.
o
Could be due to anti-spam settings of the server.
The server does not support the authentication mode used by the device.
o
Try without authentication or use a different server (sender address).
V. 02 – 22/05/2012
CAMIP5N
15 ©Velleman nv