Safety And Warnings; Safety Decals; General Safety Rules - Little Wonder 2230S Manuel D'utilisation Et Consignes De Sécurité

Safety and Warnings

WARNING - DANGER
IMPROPER USE OR CARE OF THIS TRIMMER,
OR FAILURE TO WEAR PROPER PROTECTION
CAN RESULT IN SERIOUS INJURY.
READ AND UNDERSTAND THE RULES FOR
SAFE OPERATION AND ALL INSTRUCTIONS
IN THIS MANUAL.
WEAR HEARING PROTECTION.
A.

Safety Decals

An important part of the safety system incorporated in this
trimmer are the warning and information decals found on
various parts of the trimmer. These decals must be replaced in
time due to abrasion, etc. It is your responsibility to replace the
decals when they become hard to read. The location of these
decals and their part numbers for ordering are shown below.
B.

General Safety Rules

1. THIS MACHINE CAN CAUSE SERIOUS INJURIES. Read
the instructions carefully for the correct handling, preparation,
maintenance, starting and stopping of the machine. Be familiar
with all controls and the proper use of the machine. Pay
particular attention to all sections regarding safety.
WARNING!
READ AND UNDERSTAND
OWNER'S MANUAL BEFORE
USING! KEEP IN SAFE PLACE!
STARTER HANDLE
EAR/ EYE
PROTECTION PRIMER BULB
LABEL P/N 4036
LITTLE WONDER
LABEL P/N 357
MUFFLER
LOCKOUT
TRIGGER
STOP
SWITCH
THROTTLE
TRIGGER
REAR
HANDLE
GEAR HOUSING
FUEL TANK CAP
4
WEAR EYE AND EAR
PROTECTION
CUTTING HAZARD! KEEP BOTH
HANDS ON HANDLES AND
AWAY FROM BLADES!
CUTTING
THROTTLE CABLE
BLADES
SPARK PLUG WIRE
CHOKE KNOB
AIR CLEANER
ADJUSTING
SCREW AND
BLADE GUARD
FRONT SIDE HANDLE
MODEL NO. LABEL
WARNING LABEL P/N 300605
2. Always keep a firm grip on both handles while the blades
are moving and/or the engine is running. On double edge units
one hand grasps the front loop handle, while the other hand
grasps the rear handle. On single edge units the right hand
grasps the front side handle and the left hand grasps the rear
handle. BE AWARE!! The blades coast after throttle trigger
is released or engine is switched off. Make sure blades have
come to a complete stop and engine is off before releasing a
handle.
3. Maintain a firm footing and good balance, do not overreach
while trimming. Before you start to trim, check the work area
for obstacles that might cause you to lose your footing, balance
or control of the machine. While operating the machine always
be sure of a safe and secure operating position especially when
using steps or a ladder.
4. Keep area clear of children, pets, and bystanders.
5. Blades coast after throttle trigger is released or engine is
switched off.
6. Stop the engine before checking, maintenance or working
on the machine.
7. Never operate without guards, handles and safety devices
in place.
8. Never attempt to use an incomplete machine or one fitted
with an unauthorized modification.
9. To reduce fire hazard, keep engine and silencer free of
debris, leaves, or excessive lubricant.
10. Know how to stop the machine quickly in an emergency.
WARNING - DANGER
IF TRIMMER IS USED IMPROPERLY OR SAFETY
PRECAUTIONS ARE NOT FOLLOWED. THE
USER RISKS SERIOUS INJURY TO
THEMSELVES AND OTHERS.
READ AND UNDERSTAND THE FOLLOWING
BEFORE ATTEMPTING
TO OPERATE THIS HEDGE TRIMMER
WARNING SYMBOLS
FRAME
SPARK PLUG WIRE
BAR
FUEL TANK CAP
MUFFLER
STOP SWITCH
LOCK OUT TRIGGER
REAR HANDLE
THROTTLE TRIGGER
CUTTING
SERIAL NO.
BLADES
LOOP HANDLE
CHOKE
KNOB
ADJUSTING
SCREW & NUT
SAFETY COMB
PRIMER BULB
STARTER HANDLE
AIR CLEANER
GEAR HOUSING
FRAME BAR