Service Maintenance Guide; Blade Adjustment - Little Wonder 2230S Manuel D'utilisation Et Consignes De Sécurité

C.

Service Maintenance Guide

Area
Air Filter
Fuel Filter
Spark Plug
Carburetor
Cooling System
Muffler (Spark Arrestor)
Gear Housing
Blades
Fuel Leaks
Fasteners
Labels
Handles
Guards / Safety Devices
Fuel Line
Starter Rope
Fuel Strainer
Choke
Ignition System
† Replacement will be required for commercial use after 600 hours. For customer use, cleaning every six months is required.
Cleaning includes rebuild kits.
IMPORTANT: Time intervals shown are maximum. Actual use and your experience will determine the frequency of required
maintenance.
D. Blade Adjustment and Comb
Orientation
The care and adjustment of the blades is very important to the
efficient operation of the trimmer and especially to the long life of
the engine.
1. Place trimmer in vise, clamping on the frame bar. Be careful!
Blades are sharp!
2. Using a 7/16" wrench, loosen all blade locknuts and unscrew the
large head screws by two turns.
3. Starting with the screw nearest the gear housing, tighten the
screw until the blade guard of the single edge trimmer or the
protective comb of the double edge trimmer
Single Edge
Maintenance
Clean
Replace
Inspect / Replace
Clean
Replace
Check / Rebuild
Replace
Inspect / Clean
Inspect / Clean
Check Grease
Inspect / Clean / Lubricate
Inspect / Repair
Inspect / Tighten / Replace
Inspect / Replace
Inspect / Replace
Inspect / Replace
Inspect / Replace
Inspect / Replace
Replace
Check
Clean
Replace
can just be moved with finger pressure and a .0015" (1 1/2 thou.)
feeler blade just slips under the blade guard or comb. Tighten the
locknuts while holding the screw stationary in its correct adjusted
position.
4. Repeat Step 3 on the screws in turn until all are correctly
adjusted.
5. Orientation of the comb is very important. The comb has
staggered teeth for better cutting performance. Correct comb
orientation is shown below.
NOTE: Correct blade adjustment can only be achieved on
oiled blades.
Double Edge
Frequency
Daily or every 4 hrs. use
Every 3 mths. or 100 hrs. use
Monthly
Every 3 mths. or 100 hrs. use
6 months or 300 hrs. use
6 months or 300 hrs. use
Yearly or 600 Hrs. use †
Before Use
Monthly
Every 50 hours of use
After Use
Before Use
Before Use
Before Use
Before Use
Before Use
Monthly
Monthly
Every 3 mths. or 100 hrs. use
With each re-fueling
No maintenance
For coil and flywheel
Comb Orientation
clean,
11