Preventive And Corrective Maintenance; Lubrication; Cleaning The Bottom Stapler; Removing Jammed Staples - Josef Kihlberg B561PN Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Josef Kihlberg B561PN

KUDA PACKAGING

Before carrying out any maintenance

tasks on the bottom stapler always

first disconnect it from the air supply.

7.1 LUBRICATION

The linkage bearings are greased at delivery.

At regular intervals (monthly) lubricate them with oil.

Also lubricate the moving parts in the stapling head

with a few drops of oil.

7.2 CLEANING THE BOTTOM STAPLER

This bottom stapler does not require special servicing.

It only needs regular cleaning with a non-aggressive

(non-corrosive) cleaning agent. Do not remove any

parts for cleaning purposes!

Check the proper functioning of all safety

devices daily. Make especially sure that:

–

the foot valve safety latch and the protector move

freely without binding or sticking.

–

all screws and nuts are securely tightened.

7.3 REMOVING JAMMED STAPLES

Before carrying out any maintenance

tasks on the bottom stapler always

first disconnect it from the air supply.

– Pull the pusher back to take the pressure off the

staple strip.

– Slightly loosen the five screws (Fig. 11/1 and 11/2)

that hold the front plate one turn.

– Remove the jammed staple downwards.

– Retighten the five screws.

SERVIS A NAHRADNÍ DÍLY

www.kuda-packaging.com