Initial Operation; Installation; Compressed Air Connection - Josef Kihlberg B561PN Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Josef Kihlberg B561PN

KUDA PACKAGING

5.1 INSTALLATION

The bottom stapler is delivered with the rear foot dis-

assambled. Assemble as following:

1. Remove the bottom stapler and the rear foot from

the carton.

2. Assemble the rear foot according to Fig. 3.

Tighten the two screws, (Fig. 3/1).

3. Place the bottom stapler on level, firm and clean-

working ground.

Lay the compressed air hose so that

there is no risk of tripping over it.

5.2 COMPRESSED AIR CONNECTION

Properly prepared compressed air is essen-

tial for troublefree operation of the bottom

stapler. This can only be ensured by a reliably functio-

ning maintenance unit, consisting of water separator,

pressure reducing valve with pressure gauge.

The internal diameter of the pipe should be at least

10 mm (

").

The bottom stapler doesn´t need any lubrication.

Connect and adjust the air pressure to the lowest

possible, approx. 5,0 bars (72 psi), which clinch the

staples correctly.

Never exceed the maximum permitted air

pressure of 8 bar (110 psi). The maximum

supply pressure is 8 Bar (110 psi).

Low air pressure will give low mainte-

nance costs!

SERVIS A NAHRADNÍ DÍLY

www.kuda-packaging.com