Lubrication; Replacing Carbon Brushes - Makita DJS130 Manuel D'instruction

Adjust the side blade L so that the curl of waste material
does not contact the cutting head or the workpiece. Use
the hex wrench to loosen the three screws which hold
the cutting head. Move the side blade L back and forth to
adjust it. Then tighten the three screws with the hex
wrench.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.

Lubrication

1
2
3
5
4
009022
Before operation, lubricate the contact point of the
center blade and the side blades R/L. And, also lubricate
the point of the center blade near the cutting head. To
keep good cutting performance, use lubricant from time
to time during operation.

Replacing carbon brushes

1
006258
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
First remove the holder by unscrewing the hex socket
head bolt.
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Lubricate
1. Limit mark
8
2
009048
Then loosen the hex socket head bolt that fastens the
barrel and turn the barrel counterclockwise.
1
2
009049
Use a screwdriver to remove two screws then remove
the front cover.
009023
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
006816
Use pliers to remove the carbon brush caps of the
carbon brushes. Take out the worn carbon brushes,
insert the new ones and replace the carbon brush caps
in reverse.
1. Holder
1 2. Hex socket head
bolt
1. Barrel
2. Hex socket head
bolt
1. Front cover
2. Screws
1
2
1
1. Spring
2. Arm
3. Recessed part
2 3