Makita DJS130 Manuel D'instruction page 7

009050
2. Loosen the bearing assembly with provided wrench
while keeping the spindle still by grabbing the two
flat parts on the spindle still with another wrench.
009051
3. Remove the bearing assmbly (thin one) and screw
the bearing assembly for gauge 16 onto the spindle
and firmly tighten it with the provided wrench while
keeping the spindle still by placing another wrench on
the two flat surface on the spindle.
4. Install the optional cutting head by referring to the
section titled " Installing cutting head ".
CAUTION:
Do not confound the bearing assembly provided
•
on the tool (thin one) with that for cutting head for
capacity of gauge 16 (Optional Accessory). The
bearing assembly
while that for cutting head for capacity of gauge
16 (Optional Accessory) is thick.
Hex wrench storage
009021
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
provided on the tool is thin
1. Hex wrench
1
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow (1)
and raise it in the direction of the arrow (2).
1
2
1
1
009015
OPERATION
009020
1
2
3
009018
CAUTION:
Edges and chips of the workpiece are sharp. Wear
•
gloves. Otherwise it can cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece
surface.
Adjusting shear blade
1
2
3
4
009019
7
1. Hook
1. Side blade
2. Side blade
surface
3. Center blade
4. Workpiece
4
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve
5