Lubrication - Makita BJS130 Manuel D'instruction

16 (Optional Accessory) is thick.
Hex wrench storage
009021
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow (1)
and raise it in the direction of the arrow (2).
1
2
1
1
009015
OPERATION
009020
1
2
3
4
009018
1. Hex wrench
1
1. Hook
1. Side blade
2. Side blade
surface
3. Center blade
4. Workpiece
CAUTION:
Edges and chips of the workpiece are sharp. Wear
•
gloves. Otherwise it can cause injury.
Secure the workpiece firmly. Move the tool forward
keeping the side blades flush with the workpiece surface.
Adjusting shear blade
1
2
3
4
009019
Adjust the side blade L so that the curl of waste material
does not contact the cutting head or the workpiece. Use
the hex wrench to loosen the three screws which hold the
cutting head. Move the side blade L back and forth to
adjust it. Then tighten the three screws with the hex
wrench.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.

Lubrication

1
2
3
5
4
009022
Before operation, lubricate the contact point of the center blade
and the side blades R/L. And, also lubricate the point of the
center blade near the cutting head. To keep good cutting
performance, use lubricant from time to time during operation.
7
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Sleeve
5
1. Screws
2. Side blade L
3. Center blade
4. Side blade R
5. Lubricate