Maintenance - Clarke FOCUS S28 WB Manuel D'utilisation

HOW TO OPERATE THE MACHINE
How to Clean a Very Dirty Floor
To clean a very dirty fl oor, follow this procedure:
1. Apply solution to the fl oor.
2. Do not lower the squeegee.
3. Do not activate the vacuum motor.
4. Lower the brushes and scrub the fl oor.
5. Leave the solution on the fl oor long enough for the solution to begin
cleaning the fl oor.
6. Scrub the fl oor again with additional solution, picking up all the
solution with the squeegee

MAINTENANCE

WARNING!
Maintenance and repairs must be done by authorized personnel
only.
WARNING!
Always empty the solution tank and recovery tank before doing
any maintenance.
WARNING!
Keep all fasteners tight.
These Maintenance Procedures Must Be Done Every Day
Keep the machine clean, it will need fewer repairs and have longer life.
Do These Procedures When You Begin Your Work Period
1. Turn off key switch.
2. Unplug charger from AC outlet and wrap cord around bracket at
rear of machine.
3. Make sure the recovery tank lid is on correctly (see fi gure #20).
4. Make sure the Screen fi lter over the vacuum motor is clean and in
position (see fi gure #20).
5. Make sure the valve on the recovery drain hose is clean. Tightly
close the valve.
6. Make sure brush housings and skirts are in position on the brush
head.
7. Make sure the brushes are in position and installed correctly
8. Check the installation of the squeegee and squeegee hose.
Clarke
®
Operator's Manual (EN) - FOCUS S28/L28/S33/L33/S38/L38 WB
ENGLISH
EN
Figure #20
Form No. 70851A - 23 -