How To Prepare The Machine For Operation - Clarke FOCUS S28 WB Manuel D'utilisation

Masquer les pouces Voir aussi pour FOCUS S28 WB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
EN

HOW TO PREPARE THE MACHINE FOR OPERATION

How To Install The Batteries
The 28, 33 and 38 Focus machines use six 6-volt batteries. The
batteries are located in the battery compartment under the recovery
tank.
To Install the batteries, follow this procedure:
1.
Turn key switch off.
2.
Make sure both tanks are empty.
3.
Disconnect the hoses from the recovery tank (upper tank) &
unplug the vac motor and fl oat switch.
4.
Remove the tank support bracket.
5.
Remove the recovery tank.
6.
Place the batteries in the solution tank as shown in fi gures 6a
and 6b.
WARNING!
Lifting batteries without help could result in an injury.
Get help to lift the batteries. The batteries are heavy.
WARNING!
Working with batteries can be dangerous. Always wear
eye protection and protective clothing when working near
batteries. NO SMOKING!
7.
Connect the battery cables between batteries and install long
battery cable assembly as indicated. See fi gure 6a and 6b.
8.
Install the tank, reconnecting hoses and plugging in vac motor
and fl oat switch connectors. Install tank support bracket.
NOTE: Charge the batteries before using the machine.
-16- Form No. 70851A
Clarke
®
Operator's Manual (EN) - FOCUS S28/L28/S33/L33/S38/L38 WB
38722B
38722B
38720B
38722B
Figure #6a
38722B
Figure #6b

Publicité

Chapitres

Table des Matières
loading

Table des Matières