Basic Operation; Operation Condition - Sharp AH-XP10UHD Mode D'emploi

BASIC OPERATION

OPERATION CONDITION

Mode
Upper limit
Cooling
Lower limit
• The build-in safety device may prevent
the unit from operating when used out of
this range.
• Condensation may form on the air outlet
if the unit operates continuously in the
COOL or DRY mode when humidity is
over 80%.
INVERTER_OM A881_EN.indd EN-5 INVERTER_OM A881_EN.indd EN-5
1
2
3
2
4
SENSOR
3
1
4
Indoor Outdoor
Temp. Temp.
32°C 43°C
21°C 21°C
EN-5
Press the MODE button to select the
operation mode.
Press the ON/OFF button to start opera-
tion.
• The green OPERATION lamp (
TO TURN OFF
Press the ON/OFF button again.
• The green OPERATION lamp (
Press the THERMOSTAT button to set
the desired temperature, you can set
temperature in 0.5 C increments.
(AUTO/DRY mode)
The temperature can be
changed up to ±2.0°C
from the automatically
setting.
(COOL mode)
The temperature setting
range: 16.0-30.0°C.
Press the FAN button to set the desired
fan speed.
AUTO QUIET SOFT
NOTE:
AUTO MODE
In the AUTO mode, the temperature setting and mode
are automatically selected according to the room
temperature when the unit is turned on.
DRY MODE
The fan speed is preset to AUTO and cannot be changed.
WHEN POWER FAILURE OCCURES
This air conditioner has a memory function to store
setting when a power failure occurs.
After power recovery, the unit will automatically re-
start in the same settings which were active before
the power failure, except for TIMER, POWERFUL
JET, BEST SLEEP, BABY MODE, ECO MODE,SELF
CLEAN settings.
) will light up.
) will turn off.
LOW HIGH
11/8/2559 BE 5:14 PM 11/8/2559 BE 5:14 PM