DNCI
5
Fitting
Fitting mechanical components
Check the use of the DNCI
S
as a measuring cylinder
with electronic control.
Please note
Using the DNCI with electronic control:
S Use the DNCI only in the permitted mounting positions (see here the drive−
specific information on the positioning controllers).
S When fitting the mechanical parts, take into account the instructions in the
manuals for the positioning controller.
Make sure that tubing and connection accessories have sufficient space for
S
movement.
If the cylinders are arranged parallel:
Take the following minimum space requirements into account: Otherwise the
S
magnetic fields of the two cylinders will influence each other and lead to evalu
ation faults in the measuring system.
Parallel arrangement
Bearing cover flush
No minimum distance
20
Bearing cover offset (Y 0)
Minimum distance X > 70 mm
Festo DNCI 0810b English