Festo DNCI-32 Notice D'utilisation page 19

DNCI
Please note
Malfunctioning will occur if the device is not used correctly.
S Make sure that the specifications in this chapter are always observed.
Only in this way can you ensure correct and reliable functioning.
Compare the maximum values specified in these operating instructions with
S
your actual application (e.g. pressures, forces, torques, temperatures, masses,
speeds, voltages).
Only if the loading limits are observed can the DNCI be operated in accordance
with the relevant safety guidelines.
Observe the specifications applicable to your location, as well as all local and
S
national laws and regulations.
Remove all transport packaging such as foils, caps and cartons (except for any
S
plugs in the pneumatic connections).
The packing is intended for recycling (except for oiled paper which must be
disposed of ).
Observe the ambient conditions at your location.
S
Make sure that the compressed air is correctly prepared (here: filtered, dried
S
and non−lubricated / see 'Technical specifications').
Once a medium has been selected, keep this unchanged over the complete
S
service life of the product (media quality see 'Technical specifications').
Pressurize your complete system slowly until the operating pressure is re
S
ached.
All movements of the actuators will then be controlled.
For slow start−up pressurization use safety start−up valve HEL or HEM.
Use the DNCI in its original state without undertaking any modifications.
S
Festo DNCI 0810b English
19