Scrigno Antamatic Open 2.0 Manuel D'installation page 58

Open
2.0
17
Fit the cable-motor into the slot of the driven pulley.
Fit the belt in the jointing bracket, as shown in the
19
picture.
R1387 DCM2461/SCRIGNO | page 10
Pass the motor cable completely through, fi tting
18
it into corrugated duct which leads to the junction
box.
20
Pass the belt behind the driven pulley.
IMPORTANT!! The jointing bracket must be on the
opposite side of the rail, with respect to the cable transit.
EN