Beurer WL 50 Mode D'emploi page 47

• Ensure that no water enters the device. If this should happen, only reuse the device once it
has fully dried out.
• Never immerse the device, USB mains adapter, USB-C charging cable or AUX cable in water
or other liquids.
• Protect the device from impacts, moisture, dust, chemicals, marked temperature fluctuations
and nearby sources of heat (ovens, heaters).
9. What if there are problems?
Problem Possible cause
Device does ON/OFF button switched off
not light up
No electricity
No electricity
LEDs have reached the end of
their service life.
LEDs faulty.
You can find further information and a list of frequently asked questions (FAQs) about this
product at www.beurer.com.
Solution
Switch on the ON/OFF button.
Correctly connect the mains part/charge
the battery.
The mains part/the battery is faulty. Cont-
act Customer Services or your retailer.
For repairs, please contact Customer
Services or an authorised retailer.
47