Publicité
Les langues disponibles
Les langues disponibles
EN
1. Safety Instructions
1-1. Warnings and symbols
Safety instructions and warnings are marked in this manual by the following pictograms：
Supplementary information on operating the device.
CAUTION
Safety instruction: Failure to observe this instruction can cause material damage and impair the
function of the device.
CAUTION
Safety instruction relating to a danger from an electrical current or voltage. Failure to observe this
instruction can cause material damage and personal injury and impair the function of the device.
WARNING!
SAVE THESE INSTRUCTIONS – This manual contains important instructions that should be
followed during installation and maintenance of the unit.
1-2. Use for intended purpose general safety precautions
The unit is constructed as per the applicable safety-technical guidelines.
For the charging of lead acid batteries and the supply of user attached to these batteries, in permanent
systems.
For the conversion of a DC voltage from a battery to and AC voltage.
Do not expose the unit to rain, snow, spray or dust. To reduce the risk of fire hazard, do not cover or
obstruct the ventilation openings and. do not install the unit in a zero-clearance compartment.
To avoid the risk of fire and electric shock, make sure that the existing wiring is in good electrical condition;
and that the wire size is not undersized.
Do not operate the unit with damaged or substandard wiring.
Depending on the use, the AC output of the unit may require user installed breaker or fusing. The unit
incorporates standard AC short circuit protection.
The following precautions should be taken when working on the Inverter Charger：
Remove watches, rings, or other metal objects.
Use tools with insulated handles.
Wear rubber gloves and boots.
1-3. Other safety notes and installation precautions
Upon receipt, examine the shipment box for damage. Notify the carrier immediately, before opening, if
damage is evident.
Do not operate near water or in excessive humidity.
Do not open or disassemble the unit, warranty may be voided.
The DC and AC side connections should be firm and tight.
1
Publicité
