Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
4
PLUMBING CONNECTIONS
To ensure troublefree operation of the whirlpool sy-
stem in areas with particularly hard water, it is advisa-
ble to install a water softener.
BATHTUBS WITH TAPS (Fig. a)
Connect the taps to the hot water supply (
water supply ( ) (for assembly of the taps, refer to the
instructions attached).
BATHTUBS WITH COMBINED OVERFLOW AND
FILLER SPOUT (Fig. b)
Connect the hot-and-cold mix hose to the overflow filler
spout. Be certain to observe local bylaws on backflow
protection.
DRAIN CONNECTION (Fig. c)
Connect the waste to the drain using the trap provided.
5
OPERATION AND WATERTIGHTNESS TEST (tubs with whirlpool)
Having made all the plumbing and electrical connections, proceed to test the system:
1) Clean any dirt from the tub
2) Fill the tub up to the level of the overflow
3) Start the whirlpool (see user manual), then proceed to check that there are no leaks, and no error messages
displayed on the control panel.
4) Having tested the system, complete the installation of the bathtub as described below.
6
FIXING TO THE FLOOR - panelled bathtubs only
Anchor the bathtub to the floor by fixing the feet as indicated in the drawing, using the screws and masonry plugs pro-
vided.
Bathtub with three panels
8
a
) and the cold
Bathtub with two
Bathtub with one panel
panels
c
b
Corner bathtub
Publicité
Table des Matières
