Vito Agro VIR47 Mode D'emploi page 38

Never store the tool with petrol in the tank inside a building.
Petrol vapours may come into contact with flames or sparks
and explode.
Store the appliance in a dry area with the fuel tank empty
and the fuel in a well-ventilated compartment. Avoid places
with high humidity to avoid the appearance of corrosion
and rust.
Clean the machine thoroughly before storage, especially in
winter. Keep the device in a good operating mode.
Make sure the device is protected against misuse use (for
example, by children).
Your device must only be repaired by the brand's technical
service or qualified professionals and only with original
spare parts.
1. Lift the green cover of the handlebar support;
2. Unscrew the screw completely with the supplied hex key;
3. Remove the upper handlebar support and place the
handlebar in the concavity of the lower handlebar
support;
4. Do the opposite process to fix the handlebar.
The blade guard avoids the projection of loose objects and
accidental contact with the user.
The blade guard should always be assembled when
using the nylon line. It should be removed when
using the grass blade.
1. Attach the blade/guard to the axis and tighten with two
screws;
2. Insert the blade guard into the groove;
3. Then press it into position with the claws;
1. 4.The guard is easily removed using a screwdriver.
The blade guard does not protect the user against all
objects (stones, glass, wire, etc) that are designed by
the cutting accessory. These objects can bounce off any
surface and hit the user.
Check the state of the blade before assembling it to the
appliance. If it is damaged (cracked, folded or broken)
replace it.
1. Place the upper fixing plate on the output shaft;
2. Turn the blade spindle until the hole in the upper
clamping plate is aligned with the corresponding hole in
the top of the protective cover;
3. Insert the locking pin into the hole to lock the shaft;
4. Place the blade, lower fixing plate and base of the
protective cover on the output shaft;
5. To tighten the nut, turn the key in the opposite direction
of rotation.
6. Remove the locking pin after complete installation.
1. Place the upper fixing plate on the output shaft;
2. Turn the blade spindle until the hole in the upper fixing
plate is aligned with the corresponding hole in the upper
protective cover;
3. Insert the locking pin in the hole to lock the shaft;
4. Screw into the cutting head in the opposite direction to
the direction of rotation.
1. Press the fixing tabs and remove the cutting head cover;
2. Remove the reel from the cutting head and remove the
line;
3. Prepare about 5m of nylon line and fold it in half;
4. Fix the line in the groove of the central spacer of the reel,
in the position of the fold;
5. Roll both extremities in parallel, one in each side of the
central spacer, clockwise (arrow shown on the reel);
6. Attach the ends of the line to the outer fixing grooves of
the reel;
7. Insert the reel into the cutting head cover;
8. Release the line from the fixing grooves and insert the
ends of the line into the grooves of the cover;
9. Place the cutting head cover.