Scheppach Ke 70m Manuel D'instructions page 28

Fig. 6
Fig. 7
Fig. 8
A
D
m Attention! When installing the saw blade, pay attention to the correct direction of rotation!
28 GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
6 To lock the saw blade into place, insert the locking pin
G
7 Loosen the saw blade with the supplied open-end spanner
8 After changing the saw blade, push the protective basket
9 Carefully set down the table (D) using both hands until it
10 Slide the table backwards until the table lock (H) is above
11 Slide the table forward, reattach the tension spring (F).
12 Lock table stop again (E).(Fig. 1)
(G) through the corresponding opening on the saw blade
guard. To do this, insert the pin completely and straight
into the hole. Use the corresponding hole (depending on
the saw blade type) so that the pin is at the lowest point
(bottom of the tooth). (Fig. 6)
/ Allen wrench.
Remove saw blade flange and saw blade
Insert the new saw blade.
Mount the saw blade flange again and tighten the clamp
screw. (Fig. 7)
Remove the locking pin.
m Attention! When inserting the saw blade, make
sure the running direction is correct!
(A) onto the table (D), simultaneously lift the table and
carefully tilt it backwards. (Fig. 8)
rests on the guide (Fig. 4).
the ball bearing (J). Pull the table lock (H) outwards using
the locking pin (G) until the ball bearing (J) engages in
the guide. (Fig. 3)
(Fig. 2)