Citizen CT-S851 II Mode D'emploi page 40

3.1 0 Adjusting the Paper Near-end Sensor
Change the settings of the paper near-end sensor to set the position at which
the near-end of the paper is detected.
1. Use a pointed object, such as a pen, to gently press the button to change the pap er
near-end sensor.
2. Press and hold dow n the button whil e moving the pap er near-en d sensor up, down,
right and left. The sensor positions are shown below for the various diameters of the
paper roll used.
Senso r position
A
B
*
C
Note:
*: Position of sensor when shipped from factory. However, factory settings differ depending on the
destination market.
CAUTION
 The amount of paper remaining on the roll (diameter of the roll) depends on the type
of paper used.
 The paper roll diameters in the table are guidelines.
Button to change paper
near-end sensor
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Diamet er when detected as near end
31
23
Paper near-end sensor function is off
V10 CONSUMIBLES S.L.
Outer diameter of core of pape r roll used
— 36 —
(Unit: mm)
18
18