Publicité
Make sure that the detergent divider is
inserted properly and does not cause a
blockage when you close the drawer.
Setting a programme
1. Turn the programme dial to select the
desired washing programme.
The indicator of the Départ/Pause
button flashes.
The display shows an indicative
programme duration.
2. To change the temperature and/or the
spin speed, touch the related buttons.
3. If desired, set one or more options by
touching the related buttons. The
related indicators illuminate on the
display and the given information
changes accordingly.
If a selection is not possible
an acoustic signal sounds.
Starting a programme
Touch the Départ/Pause
start the programme.
The related indicator stops flashing and
stays on.
The programme starts, the door is locked.
The display shows the indicator
The drain pump can operate
shortly before the appliance fills
water.
Starting a programme with the
delay start
1. Touch the Départ Différé
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
2. Touch the Départ/Pause
The appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
button to
.
button
button.
.
Cancelling the delay start after
the countdown has started
To cancel the delay start:
1. Touch the Départ Différé
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
Touch the Départ/Pause
appliance lock the door and starts the
countdown of the delay start. The display
shows the indicator
When the countdown is completed, the
programme starts automatically.
2. Touch the Départ/Pause
pause the appliance. The related
indicator flashes.
3. Touch the Départ Différé
repeatedly until the display shows
and the indicator
4. Touch the Départ/Pause
again to start the programme
immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Départ/Pause
pause the appliance. The related
indicator flashes.
2. Touch the Départ Différé
repeatedly until the display shows the
desired delay time.
3. Touch the Départ/Pause
again to start the new countdown.
The SensiCare System load
detection
After touching the Départ/Pause
button:
1. The SensiCare System starts
estimating the weight of the load to
calculate the real programme duration.
During this phase the Time Manager
21
button
button. The
.
button to
button
goes off.
button
button to
button
button
Publicité
