Publicité
12
DIAL AND BUTTONS
Introduction
The options/functions are not
available with all washing
programmes. Check the
compatibility between options/
functions and washing
programmes in the
"Programme Chart". An option/
function can exclude another
one, in this case the appliance
doesn't allow you to set
incompatible options/functions.
Marche/Arrêt
Press this button for a few seconds to
activate or deactivate the appliance. Two
different tunes sound while switching the
appliance on or off.
As the Stand-by function automatically
deactivates the appliance after several
minutes to reduce the energy
consumption, you may need to activate
the appliance again.
For more details, refer to Stand-by
paragraph in Daily Use chapter.
Temp.
When you select a washing programme,
the appliance automatically proposes a
default temperature.
The indicator Froid
The indicator of the set temperature
comes on.
Essorage
When you set a programme, the appliance
automatically sets the maximum spin
speed allowed except programme Denim.
Additional spin options:
• No Spin
. The related indicator
comes on.
Set this option to deactivate all spin
phases. The appliance performs only
the draining phase of the selected
= cold water.
washing programme. Set this option for
very delicate fabrics. The rinse phase
uses more water for some washing
programmes
• Rinse Hold
comes on.
The final spin is not performed. The
water of the last rinse is not drained out
to prevent the fabrics from creasing.
The washing programme ends with
water in the drum.
The door stays locked and the drum
turns regularly to reduce creasing. You
must drain the water to unlock the door.
If you touch the Départ/Pause
button, the appliance performs the
spinning phase and drains the water.
• Nuit
. The related indicator comes
on.
The intermediate and the final spinning
phases are suppressed and the
programme ends with water in the
drum. This helps to reduce creasing.
The door stays locked. The drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available.
In some programmes the rinses are
performed with more water.
If you touch the Départ/Pause
button, the appliance performs only the
draining phase.
The appliance empties the
water out automatically after
approximately 18 hours.
Prélavage
With this option you can add a prewash
phase to a washing programme.
The relevant indicator illuminates.
• Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
. The related indicator
Publicité
