Commissioning, Operation; Mounting The Instrument - WIKA S-10 Mode D'emploi

5. Commissioning, operation

5. Commissioning, operation

5.1 Mounting the instrument

Prior to commissioning, the pressure transmitter must be subjected to a visual inspection.
Leaking fluid is indicative of damage.
■
Only use the pressure transmitter if it is in perfect condition with respect to safety.
■
Requirements for mounting point
The mounting point must meet the following conditions:
Ambience corresponds to a max. pollution degree of 3.
■
Humidity ≤ 80 % r. h. (non-condensing).
■
Protected from weather influences.
■
Sealing faces are clean and undamaged.
■
Sufficient space for a safe electrical installation.
■
For information on tapped holes and welding sockets, see Technical information IN 00.14 at www.wika.com.
■
Permissible ambient and medium temperatures remain within the performance limits. Consider possible restrictions
■
on the ambient temperature range caused by mating connector used.
→ For performance limits, see chapter 9 "Specifications"
Sealing variants
Parallel threads
Seal the sealing face  with a flat gasket, lens-type
sealing ring or WIKA profile sealing.
Tapered threads
Wrap threads with sealing material (e.g. PTFE
tape).
WIKA operating instructions pressure transmitter, model S-10

per EN 837
NPT, R and PT

per DIN 3852-E
EN
9