Blowing Function; After Ironing - Euroflex MonsterIB 40 CL GREEN Notice D'utilisation

INSTRUCTIONS FOR USE IB 40 CLASSIC

Blowing function

The blowing allows you to iron without downward pressure on a cushion of air.
This makes ironing of delicate items, or difficult areas (trousers folds, pockets, seams,
difficult areas to reach), much easier and avoids the "false ceases" that seam
crushing can produce.
IB40 Classic RAS Model - Suction and Blowing
This model has the additional blowing function
- For continuous suction function set the selector
switch on position "I".
- For continuous blowing function set the selector
switch on position "II".
- With the switch in position "0" suction and
blowing functions are switched off.
Important: Do not rest the warm iron directly on the Iron storage shelf, always use
the iron-rest mat included.

After ironing

- Leave the board on for 10 minutes to dry the cover and remove any
possible condensed water from the board.
- Turn off the ironing board using the power on/off switch.
- Remove the plug from the socket.
- Let the equipment cool completely.
- Remove the iron cord support.
- Place the iron on the iron rest pad.
- Unplug the iron/steam generator from the auxillary socket and remove it from
the board.
- Fold the shelf back over the ironing surface.
- Wind the power supply cord on to the cord winder lugs beneath the board.
- Hold the board leg with your foot to stop it skidding.
- Operate the height adjustment lever and close the board.
Note: do not entangle the power cord
- Store the closed board in a vertical position with the folded shelf end towards
the floor.
- Always ensure that the board does not skid and tilt. Store the equipment in a
dry place and out of reach of the children.
19
Selector switch