Ib 40 Classic Start Up; Suction Function - Euroflex MonsterIB 40 CL GREEN Notice D'utilisation

INSTRUCTIONS FOR USE IB 40 CLASSIC

IB 40 CLASSIC START UP

If you are using a steam generator
- Place the iron/steam generator on the shelf (9).
If you are using a steam iron
- Place the iron (soleplate down) on the iron rest mat which should be
positioned at the rear end of the ironing surface.
- Plug the power supply cord from your iron/steam generator into the auxillary socket
built-in to the ironing board.
- Plug the power supply cord from your ironing board into a 13amp wall socket and switch
the socket on.
- Switch the equipment on using the power on/off switch. The power on/off switch acti-
vates the ironing board and the steam generator or steam iron plugged into the auxillary
socket. An integrated thermostat constantly controls the board heating temperature.
During the heating phase the equipment may emit noises. This is a normal phenomenon,
which is nothing to worry about.
Power indicator light
Power on/off switch
Suction function and heating of board
The suction absorbs the superfluous steam, which is no longer used after the ironing
process. The suction helps hold the garment on the ironing surface and helps to dry the
garment. Clean ,dry clothes are obtained, ready to be placed straight in the wardrobe
without further airing. The heated ironing surface stays dry, and keeps the steam hot so
that it passes through the cover and board to be expelled without condensing.
Recommendation:
- Through the suction function, light fabrics (silk etc.) can be held in place on the
ironing board, preventing them from slipping.
- The suction function cools the fabric and "fixes" the results of the ironing,
guaranteeing for ex. perfect folds
IB40 Classic RA Model - Suction only
This model has no blowing function
- For continuous suction set the selector switch on
position "I".
- With the switch in position "0" the suction func-
tion is switched off.
Selector switch
18
Selector
switch