Technical Data; Maintenance And Cleaning; Putting Into Operation - EINHELL DTA 25/2 Instructions D'utilisation Et D'entretien

Anleitung_DTA_25_2_SPK1:_
Repairs and maintenance work are to be carried out
only by authorized specialist workshops.
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.

4. Technical data

Permissible working pressure max.
Air consumption approx. ca. 0.11 L/blast
Staple width
Staple length
Nail length
Recommended hose diameter
Sound pressure level L 80.8 dB(A)
pA
Sound power level L 93.8 dB(A)
WA
Vibration a
w
Air quality
cleaned and oiled
Air supply
via conditioning unit with filter pressure reducer
and mist oiler
Compressor capacity
approx. 250 l/min. equivalent to a motor rating of 2.2
kW
Work settings
6 bar working pressure set at the pressure
reducer or filter pressure reducer
Please note:
When working with the stapler, be sure to wear
the necessary protective clothing, particularly
goggles.
Observe the safety regulations.

5. Putting into operation

Screw the supplied plug-in nipple into the air
connection. To fill the magazine, press on the
magazine lever and pull back the lower magazine
shaft as far as the stop. Insert the staples/nails into
the magazine rail from above. Do not insert more
than one complete stick of staples/nails or the
magazine will be too full and can no longer be
10.02.2009 16:37 Uhr
closed. After connecting the stapler to the air supply,
place it in stapling/nailing position and pull the trigger
lever. The trigger lever has to be released after each
shot.
Automatic operation: If you keep the trigger lever
pressed, the staples/nails will be shot automatically
when the stapler is placed against the workpiece.
Be careful not to staple twice in the same place.
Caution !
If a staple/nail becomes stuck in the piston shaft, first
7 bar
disconnect the stapler and make sure it is not under
any pressure before you remove the cover plate.
With the magazine open and the rest of the
5.7 mm
staples/nails removed you can then take out the
13-40 mm
jammed staple. Clean the shaft if necessary and
10-50 mm
close again.
9 mm Ø

6. Maintenance and cleaning

2.5 m/s 2
Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service.
Before starting to work, always check that the
magazine is secure. Clean the tool thoroughly when
you are finished with your work.
Regular lubrication is vital for the long-term, reliable
operation of your stapler. Use only special tool oil for
this purpose.
You can choose from the following options for
lubricating the tool:
6.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
6.2 By hand
If your air system has neither a conditioning unit nor
a line oiler, you must feed 3-5 drops of special tool oil
into the air connection each time before you use your
stapler. If the pneumatic tool has not been used for
several days, you must feed 5-10 drops of oil into the
air connection before you switch on.
Keep your pneumatic tool in dry rooms only.
Seite 9
GB
9