Télécharger Imprimer la page

Montage Et Raccordement; Prise De Terre - Horizont hotSHOCK A50 Mode D'emploi

Masquer les pouces Voir aussi pour hotSHOCK A50:

Publicité

Switch-on and off of the electric fencer:
Send a SMS to the additional device with following content:
The given answer of the additional device will be:
The additional device will switch-on the electric fencer.
Send a SMS to the additional device with following content:
The given answer of the additional device will be:
The additional device will switch off the electric fencer. The frequent tick of the fencer will stop and the fencing voltage
advice will not show any voltage. The additional device still operates.
Caution! If the fencer was switched off with the instruction "poweroff", you have to switch on again with "poweron".
Summertime and wintertime settings for the additional device:
Send a SMS to the additional device with following content:
or
Time zone 1 will regulate the additional device to winter time.
Timezone 2 will regulate the additional device to summer time.
The SMS won't confirm from the module. You will receive with the next SMS on call the current regulated time.
Reset on factory setting:
Send a SMS to the additional device with following content:
The given answer of the additional device will be:
The additional device has been reset on factory setting.
Registering mobile phones:
IThe fencer accepts the communication with your mobile phone up to 4 more mobile phones. For this you need to
register your mobile phone as "Master":
Send a SMS to the additional device with following content:
Beispiel: admin 00491718952860 (admin=Befehl; SPACE;
0049=country identification, 1718952860=YOUR mobile phone number)
Advise: To avoid further communication problems during the data transfer, please insert YOUR mobile number as its
deposited as "My number" in your own mobile phone.
Example: 00491718952860 or +491718952860 or 01718952860
The telephone numbers disagree with the country identification.
The given answer of the additional device will be
Additional mobile phones can be registered by the master mobile phone:
Send a SMS to the additional device with following content:
Example: admin 0049171xxxxxxxxx(admin=Advise; Space;
0049= country identification; 171xxxxxxx= FURTHER mobile numbers
Additional mobile phones can be registered by the master mobile phone:
Send a SMS to the additional device with following content:
Example: admin 0049171xxxxxxxxx(admin=Advise; Space;
0049= country identification; 171xxxxxxx= FURTHER mobile numbers
As before registered mobile phones just can check out when the additional device will be reset on factory setting.
Desired settings have to be reinstalled.
Any registered phone can serve the electric fencer as described. Alert messages will be sent to all registered phones.
All other confirmations will send to the phone which has activated the instruction.
Please look out for a stable mobile reception and a good cover with GPS-satellites
Depending on the mobile reception and the additional device it can be a time delay during SMS sending. Also can
accrue time delays because of the communication between different network operators.
The quantity of the satellites can vary because of bad meteorological conditions, fencer location under roofs or other
shields. The establishment can be impossible or incorrect. It can amount to incorrect establishments of the additional
device because of satellite drift.
Please ensure a good "view" from the electric fencer to the GPS-satellites to avoid time delay during the site location
or impreciseness during the establishment.
10
poweron
poweron ok
poweroff
poweroff ok
time zone 1
time zone 2
begin
begin ok
admin YOUR MOBILE NUMBER
admin IHRE Mobiltelefonnummer ok
admin WEITERE Mobiltelefonnummer
admin FURTHER mobile numbers
Mode d'emploi pour électrificateur hotSHOCK A50
fr
avec GPS SECURITY et SMS CONTROL
en relation avec les conseils de sécurité SECURA ANIMAL
ou SECURA SECURITY (www.horizont.com)

Montage et raccordement:

L'appareil peut être monté au choix sur un mur ou sur un piquet solide. Le piquet de mise
à la terre doit être enfoncé le plus profond possible dans le sol à un endroit humide et relié
à la borne de terre (
) de l'électrificateur par un fil non corrosif.
Raccorder le câble de raccordement de la clôture (
ll n'est protégé de l'humidité que par un montage correct.
Ne pas exposé directement au soleil.
Ne pas mettre en marche l'appareil couché sur le sol.
Mise en service et contrôle (fig. 2) :
Raccorder l'accumulateur 12V, veiller à ce que les bornes polaires soient propres et à la
bonne polarité ( rouge + / noir - ).
Utilisez seulement 12V batteries-Gel-Plomb (rechargeables), les batteries-Gel-Plomb doivent
être placées dans un espace ventilé.
Presser l'interruteur (1)
„accu-test" (2) lumière constant vert
no lumière et lumière clignotante vert = charger accu
Quelques secondes après on entend un tic-tac régulier, l'appareil est en marche. Le lampe
temoin (3) clignote au rythme des impulsions électriques (fig. 2). L'impulsion de la lampe
de contrôle (3) montre le bon fonctionnement de l'appareil. Lumière permanente ou lampe
"éteinte" indiquent pas de tension électrique ou bien defect de l'électrificateur.
La clôture peut être branchée sur l'une des 2 bornes de l'appareil selon la puissance voulue :
(Z1) = puissance maximale
(Z2) = puissance réduite (fig. 2)
Les 2 bornes peuvent être employées en même temps avec 2 clôtures différentes. Un court
circuit sur la clôture reliée à Z2 a peu d'influence sur Z1 mais un court-circuit sur Z1 entraîne
une réduction de puissance sur Z2.

Prise de terre:

Une bonne prise de terre est particulièrement importante pour le bon fonctionnement et la
performance maximum de l'électrificateur; c'est pourquoi la prise de terre doit être faite à
un endroit le plus humide possible et couvert de végétation. Placer une barre de fer à 1 m
de profondeur (par exemple une barre ronde de 12 mm de diamètre). Par sol sec et clôture
longue, on devra poser un conducteur de terre supplémentaire avec des prises de terre
intermédiaires (tous les 50 m) le long de la clôture (fig. 4).
Maintenance:
Seulement du personnel qualifié est autorisé à effectuer des réparations.
Il ne faut utiliser que des pièces de rechange ordonnées par le producteur.
ou
) - fig. 3.
= accu bon
11

Publicité

loading

Ce manuel est également adapté pour:

10613gpsd