CONTROL DEVICES
WARNING! For the system to work properly, before fitting any snap-in card (e.g. the AF R800), you MUST CUT OFF THE MAIN POWER
SUPPLY and remove any batteries.
10 11 TS 1 2 3 3P 4 5 7 CX CY
A B S1 GND
Keypad selector.
STOP button (NC contact). For stopping the gate while excluding automatic
closing. To resume movement either press the control button or any other
control device.
Activate the F1 programming function. If the button is no used, leave
this function deactivated.
OPEN ONLY function from control device with NO contact.
Warning: in MAINTAINED ACTION mode, the control device must be connected
to 2-3.
PARTIAL OPENING function from control device (NO contact)
ONLY CLOSE function from control device (NO contact).
Warning: in MAINTAINED ACTION mode, the control device must be connected
to 2-4.
OPEN-CLOSE-INVERT (step-by-step) function from control device (NO contact).
Alternatively, from the functions programming you can activate the single
command OPEN-STOP-CLOSE-STOP (sequential).
See function F7.
Antenna with RG58 cable for remote control.
Connector for the AF (AF43S or AF868) card, for
controlling the gate via a transmitter.
BLACK
RED
Connector for the R700 card (for using the transponder
selector or the card reader) or for the R800 card (for using
the keypad selector).
To set the type of selector, see function F14
Transponder or card reader.