Everglades EVUD4041 Mode D'emploi page 57

8. Screw out lower hinge, change it to the
near hole site, and then screw up.
9. Just remount to the step 7, change part
① ②,⑤
to left and part
① ④ .
fix part with screws
part ③ .
1
4
3
10. Move the lower door and adjust its
position to align lower hole site and upper
hinge axis. Turn the middle hinge by 180,
adjust the middle hinge to the appropriate
position and then install it.
11. Screw out the upper hinge axis, turn the
upper hinge over and fix axis on it. Then
place it at side for use.
to right and then
12.
Finally install
then install it to the right side
shown in figure below.
5
2
1
13. Move the upper door to appropriate
position, adjust part
and then fix part
hold upper door by hand when installing) ,
and then install another part
plastic bag).
Note: When installing part
from left to right completely, then push it
down tight.
14. Open the upper door, mount door racks
and then close it.
Remove the screw hole cover
①
and upper door,
①
by screws
③,
firstly, push it
12
① ,
② ,
as
2
② (
Please
③ (
in the
3
2
1