Publicité
Les langues disponibles
Les langues disponibles
11
Reversing the door
The side at which the door opens can be
changed, from the right side (as supplied) to
the left side, if the installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed from
the mains socket.
Note: Before you start laying the refrigerator
on its back in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the refrigerator.
To reverse the door, the following steps are
generally recommended.
1. Stand the refrigerator upright. Open the
upper door to take out all door racks (to
avoid racks damaged) and then close the
door.
2. Remove the Upper hinge cover (right) ①,
then remove the screws
③ .
①
part
Put part
just detached back to
②
plastic bag, place screws
side for use.
Note: Please hold the upper door by hand
during step 2 to prevent door dropping.
3. Remove the upper door and place it on a
smooth surface with its panel upwards.
① ,
Loose screws
and remove part
②
then install part
to the left side with
screws ①.
4. Loose screws
hinge
remove the lower door.
5. Place the lower door on a smooth
surface with its panel upwards. Loose
screws
install part
② ,
and remove
③
and part
at
1
2
6. Change screw hole covers on middle
3
cover plate from left to right (as shown in
figure below).
② ，
7. Place refrigerator flatwise, remove part
③
⑤, ②
5
2
2
1
①
used to fix the middle
②
and remove middle hinge
① ,
and remove part
②
to the left side with screws
④.
and then loose screws
①.
and part
②
. Then
2
1
② ，
then
①.
2
1
Remove part
1
4
3
Publicité
