Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
The first step of your installation should be to measure your current cutout dimensions and compare them
to the cutout dimensions chart below. You may find little or no cabinet work will be necessary.
Do not remove spacers on the side walls and/or on the back of the built-in oven. These spacers
center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result
in heat damage or fire.
NOTE:
1. Base must be capable of supporting 200 pounds (90.7 kg).
2. Make sure base is level and front of cabinet is square. If the cabinet
base is not level, the oven glides will tend to slide out
when opening the door.
** NOTE: Allow at least 23¼" (59.1 cm)
clearance for door depth when it is open.
NOTE: Dimension G is critical to the
proper installation of the built-in oven. If
the oven decorative moulding does not
butt against the cabinet, or if noise is
heard on convection models, verify
dimension G to assure it is according to
the required dimension.
* Suggested distance from floor is 31" (78.7 cm).
Minimum required distance is 4½" (11.4 cm).
MODEL
30" (76.2 cm) Wall Oven
MODEL
30" (76.2 cm) Wall Oven
All dimensions are in inches (cm).
Printed in United States
B
** Door Open
(see note)
PRODUCT DIMENSIONS
A
30 (76.2)
CUTOUT DIMENSIONS AND CABINET WIDTH
Min.
F Max.
28
½
(72.4)
29 (73.7)
1
(3.8 cm)
C
Min.
28
/
"
3
32
(71.4 cm)
Spacer
D
(78.7 cm)
A
NOTE: For combination of this Built-in Oven with Warm &
Serve Drawer model no E30WD75DSS see cutout dimensions
specified in the Warm & Serve Drawer Installation Instructions.
Figure 1
B
C (Rear wrapper)
29
½
(74.9)
G (Min.)
Min.
24 (61)
28
/
(71.8) 28
1
4
1
I
1
/
"
4" X 4" (10.2 cm x
2
10.2 cm) opening to
route armoured
G
H
F
3" (7.6 cm)
31"*
2" (5.1 cm)
Min.
28 (71.1)
24
1
.
H Max
30 (76.2) Min
/
(73.3)
7
8
P/N 318201517 (0410) Rev. B
English – pages 1-6
Español – páginas 7-13
Français – pages 14-20
cable.
Max.
Electrical
Junction Box
D
/
(61.3)
8
I

Publicité

loading

Sommaire des Matières pour Electrolux E30WD75DSS

  • Page 1 * Suggested distance from floor is 31" (78.7 cm). NOTE: For combination of this Built-in Oven with Warm & Minimum required distance is 4½" (11.4 cm). Serve Drawer model no E30WD75DSS see cutout dimensions specified in the Warm & Serve Drawer Installation Instructions. Figure 1...
  • Page 2 ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 1. A 3-wire or 4-wire single phase 120/240 or 120/208 Important Notes to the Installer Volt, 60 Hz AC only electrical supply is required on 1. Read all instructions contained in these installation a separate circuit fused on both sides of the line instructions before installing the wall oven.
  • Page 3 ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 2. If used in mobile homes or if local codes DO 3. Electrical connection NOT permit connection of the frame grounding It is the responsibility and obligation of the consumer to conductor to the neutral (white) wire, separate contact a qualified installer to assure that the electrical the white and bare copper ground wires that extend installation is adequate and is in conformance with the...
  • Page 4 ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 4. Cabinet Installation Heavy Weight Hazard • Use 2 or more people to move and install wall oven. • Failure to follow this instructions can result in injury or damage to the unit. The wall oven can tip when the door 1 1/2"...
  • Page 5 ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS Cabinet side filler panels are necessary to isolate the unit from adjoining cabinets. Approx. 3” (7.5 cm) To reduce the risk of per- sonal injury and tipping of the wall oven, the wall oven must be secured to the cabinet (s) by 36”...
  • Page 6 ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS 5. Checking Operation Model and Serial Number Location The serial plate is located inside the oven on the side If your model is equipped with an Electronic Oven trim. Control. Each of the functions has been factory checked before shipping.
  • Page 7 * Distancia sugerida desde el suelo es NOTA: Para la instalación combinada de este Horno Empotrable con Cajón Asador Modelo E30WD75DSS ver las 31" (78.7 cm). dimensiones especificadas en las instrucciones de instalacion La distancia miníma requerida es 4½" (11.4 cm).
  • Page 8 INSTRUCCIONES DE INSTALACIÓN PARA EL HORNO ELECTRICO DE PARED (Combinado con una cocina electrica o de gas facultativa) Notas importantes para el instalador 2. Requisitos Eléctricos 1. Lea todas las instrucciones contenidas en este manual Este artefacto debe ser suministrado con el voltaje y la antes de instalar el horno.
  • Page 9 INSTRUCCIONES DE INSTALACIÓN PARA EL HORNO ELECTRICO DE PARED (Combinado con una cocina electrica o de gas facultativa) 2. Este electrodoméstico debe conectarse a la caja de 1. Si los códigos locales permiten la conexión del fusibles (o de cortacircuito), por medio de un cable conductor de toma a tierra del armazón al neutro blindado flexible o un cable con forro no metálico.
  • Page 10 INSTRUCCIONES DE INSTALACIÓN PARA EL HORNO ELECTRICO DE PARED (Combinado con una cocina electrica o de gas facultativa) 4. Instalación del Gabinete El marco esta aterrizado a través del cable neutro. Si es usado el electrodoméstico en una casa movil (1996 NEC), vehiculos recreativos, o donde las leyes locales no permitar aterrizar a través del cable neutro vea figura 3.
  • Page 11 INSTRUCCIONES DE INSTALACIÓN PARA EL HORNO ELECTRICO DE PARED (Combinado con una cocina electrica o de gas facultativa) 3. Introduzca la unidad dentro de la apertura del gabinete. Deslícela dejando 1½” (3.8 cm.) entre el horno y el frente del gabinete (vea figura 5). Empuje la unidad y tire el cable blindado a través del hoyo en el piso, y hacia la caja de empalmes.
  • Page 12 INSTRUCCIONES DE INSTALACIÓN PARA EL HORNO ELECTRICO DE PARED (Combinado con una cocina electrica o de gas facultativa) Es importante instalar paneles llenadores para los para aislar el horno de pared de los gabinetes. Approx. 3” (7.5 cm) Use ménsulas de montaje para fijar el horno a los gabinetes.
  • Page 13 INSTRUCCIONES DE INSTALACIÓN PARA EL HORNO ELECTRICO DE PARED (Combinado con una cocina electrica o de gas facultativa) 5. Verificación de del funcionamiento Ubicación del número de modelo y de serie La placa de serie se encuentra dentro del horno, en el Este horno de pared puede estar equipado con un contramarco lateral.
  • Page 14 G pour s'assurer qu'elle est correcte. NOTE: Pour l'installation combinée de ce four encastré avec le tiroir réchaud E30WD75DSS référez-vous aux dimensions de * La distance suggérée du plancher est 31" (78.7 cm). découpage spécifiées dans les instructions d'installation du La distance minimale requise est 4 "...
  • Page 15 INSTRUCTIONS D'INSTALLATION POUR FOUR ENCASTRÉ ÉLECTRIQUE (Combiné à une table de cuisson électrique ou à gaz (en option)) Installateur Observez tous les règlements et les codes locaux applicables. 1. Lisez toutes ces instructions avant de procéder à l’installation de votre appareil. 1.
  • Page 16 INSTRUCTIONS D'INSTALLATION POUR FOUR ENCASTRÉ ÉLECTRIQUE (Combiné à une table de cuisson électrique ou à gaz (en option)) Par temps froid, pour protéger la La connexion inappropriée du circuit commande du four, il faut attendre au moins trois (3) heures résidentiel en aluminium à...
  • Page 17 INSTRUCTIONS D'INSTALLATION POUR FOUR ENCASTRÉ ÉLECTRIQUE (Combiné à une table de cuisson électrique ou à gaz (en option)) ÉLECTRICIEN: Le câble gainé fourni avec cet appareil est Dimensions de découpage homologué par l'ACNOR pour connexion à des circuits résidentiels de fils de calibre supérieur. La capacité 28 1/2"...
  • Page 18 INSTRUCTIONS D'INSTALLATION POUR FOUR ENCASTRÉ ÉLECTRIQUE (Combiné à une table de cuisson électrique ou à gaz (en option)) Glissez l’unité vers l’intérieur en laissant un espace de 1 1/2" (3.5 cm) entre le four et le devant de l’armoire (voir figure 5). Tout en glissant l’appareil vers l’intérieur, tirez le câble gainé...
  • Page 19 INSTRUCTIONS D'INSTALLATION POUR FOUR ENCASTRÉ ÉLECTRIQUE (Combiné à une table de cuisson électrique ou à gaz (en option)) Il faut fermer les côtés de l'habitacle par des panneaux de bois pour isoler l'appareil des armoires de chaque côté. Approx. 3” (7.5 cm) Utilisez les supports de fixation pour...
  • Page 20 INSTRUCTIONS D'INSTALLATION POUR FOUR ENCASTRÉ ÉLECTRIQUE (Combiné à une table de cuisson électrique ou à gaz (en option)) 5. Vérification du fonctionnement Emplacement du numéro de modèle et de série Si votre appareil possède une commande électronique de four, prenez note que toutes les fonctions qu'elle La plaque signalétique est située sur le côté...

Ce manuel est également adapté pour:

E30ew75ess3