Sony PS-X60 Mode D'emploi page 7

Tonearm height adjustment
For the cutomers
who purchased
non-European
or PX model:
Please skip this section.
© When the adjustment is complete, lock the Knob.
Arm rest height adjustment
@ Be sure that the Tonearm Platform is up.
Overhang check *3
@ Place the rubber mat upside down.
are engraved on the reverse side.
235 protractor.
The alignment protractors
For your turntable, use the
@ If the Shell is not parallel, readjust the stylus overhang.
1) Loosen the cartridge mounting screws and slide the cartridge
in the required direction.
2) Re-tighten the screws.
3) Recheck the balance and tracking-force adjustments.
Overhang fe)
is too long.
| of
Slide the —
cartridge backward. BS ——
—+— Correct
overhang
Overhang Oo
is too short.
Slide the cartridge a =
oe
After the adjustments are complete, install the stylus guarcd.
Anti-skating compensation *4
Turn the Anti-skating
Compensator
Ring so
that the sdected
tracking-force value is aligned with the guide mark.
Anti-skating
Compensator