Kuppersbusch FKG6800.0E Mode D'emploi page 18

Change the refrigerator door:
Remove the cover plate of
the upper end cover of the
refrigeration door and the left
decorative cover. Install the
upper shaft sleeve and the signal
line of the door body to the
other side and cover the upper
end cover plate. Take out the
right decorative cover from the
accessory bag and install it to the
other side of the upper end cover.
Remove the door self-locking,
door stop and shaft sleeve of the
refrigeration door, take out the
left door self-locking from the
accessory bag, install it on the
left side of the lower end cover of
the refrigeration door, change the
door stop and shaft sleeve to the
left side of the lower end cover of
the refrigeration door
•
Change the freezing door
Remove the shaft sleeve and cap
of the upper end cover of the
freezing door and install them at
the left and right swap positions.
Remove the door self-locking,
door stop and shaft sleeve of
the freezing door, take out the
left door self-locking from the
accessory bag, install it on the left
side of the lower end cover of the
freezing door, change the door
stop and shaft sleeve to the left
side of the lower end cover of the
freezing door.
•
Install the replaced freezing door
on the lower hinge, then install the
middle hinge and cover the hinge
hole decorative cover.
•
Remove the upper left hinge
cover and upper left hinge from
the accessory bag.
Place the refrigerated door body
on the middle hinge and install
the upper left hinge. Connect
the refrigerator top signal line
4 to the door body signal line 1,
and connect the signal line 2 to
the signal line 3. Finally, replace
the hinge decorative cover to
the right side of the box body
(note: when replacing the hinge
decorative cover to the right side
of the box body, the two inserts
on the hinge decorative cover
cut off)
middle hinge
upper hinge
The picture above is only for reference.
the physical product or statement by the
distributor
EN-18
middle hinge
decorative cover
decorative cover
inserts