Operation Guide; Preparation; Turn On Or Turn Off; Turn On - Baxtran SUPER SS Série Manuel D'utilisation

As the A/D change overflowing, display shows this with the ding sounding.
AdC
The voltage is low. You can use a short while and then charge immediately.
-BatLo-
Recharge is end.
C End
Loadcell bad connected or A/D error
Err-0
Calibration switch placed at OFF during calibration
Err-1
No enough sample (on piece counting mode)
Err-2
Calibration weigh too small
Err-3

3. OPERATION GUIDE

3.1. PREPARATION:

Adjust the base foot, watch the level, make the pan in horitzontal.

3.2. TURN ON OR TURN OFF:

3.2.1 TURN ON

Press the key, the ding sound, it displays version No. and the battery voltage level and 9, 8, 7, ..., 1, 0, the
Now the scale is in a working state.

3.2.2 TURN OFF

Long-press key.

3.2.3 AUTO-OFF:

After 10 minutes in zero, scale will auto-off.

3.2.4 LOW VOLTAGE AUTO-OFF

When the voltage lower than 5.6V, then power-off.

3.3. ZERO:

When without taring the weight display is ≤ 4% Max. capa., press the

3.4. WEIGHING:

Put weight to pan.
3.5. TARE WEIGHT:
Press the key, the weight display is "0 ", the
ve, the → 0 ← lighting, press the

3.6. SAVE POWER FUNCTION

Zero after 40 seconds, auto save power, shows "O ".
Put a weight start weighing.

3.7. BATTERY INDICATE

Battery led: means voltage higher than 6.3V,

3.8. CHARGE

Power supplied by a internal rechargeable lead acid battery (6V/4Ah). When it shows "-bAtLo-". Please turn off and charge immedia-
tely. The time of full charging is 12 - 14 hours.
→ 0 ← led off, the
key, the → T ← led off.
means voltage between 6V and 6.3V; and
key, the display shows "0 ", the
→ T ← led lighting. Pick up the weight, the weight display is negati-
USER'S MANUAL SS
"→ 0 ←". led lighting.
→ 0 ← led lighting.
means voltage lower than 6V.
EN EN
15