Télécharger Imprimer la page

Ryobi RY401026 Manuel D'utilisation page 7

Masquer les pouces Voir aussi pour RY401026:

Publicité

Les langues disponibles

Les langues disponibles

 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Lawn Mower
Start Key
Grass Catcher Bag and Frame
Mulching Plug
Side Discharge Chute
Operator's Manual
WARNING:
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not insert start key or battery pack until assembly is
complete and you are ready to mow. Failure to comply
could result in accidental starting and possible serious
personal injury.
WARNING:
To prevent accidental starting, do not make any adjust-
ments or installations with the start key or battery pack
inserted. Accidental starting of the mower during assem-
bly could result in serious personal injury.
WARNING:
Never operate the mower without the proper safety
devices in place and working. Never operate the mower
with damaged safety devices. Operating the mower with
missing or damaged parts can result in serious personal
injury.
ASSEMBLY
UNFOLDING AND ADJUSTING THE HANDLE
ASSEMBLY
See Figure 2.
NOTICE:
Do not allow the starter cable to become pinched or
trapped when raising the handle.
 Rotate the handle adjustment knobs 90 degrees.
 Raise the handle.
 Rotate the knob 90 degrees again to secure handle in
place.
ASSEMBLING THE GRASS CATCHER
See Figures 3 - 4.
 Place the grass catcher frame on a flat surface with the
handle facing down.
 Orient the grass catcher bag so the vinyl floor is facing
up, then slide the bag onto the frame. When installing,
allow the frame handle to remain outside the bag and
make sure the bag seams are located at the frame edges.
 Pull the clip over the frame rail to secure in place.
 Lift the bag's vinyl floor to the top of the frame rail and
secure in place.
 Using the same method, attach the remaining clips on
each side of the bag to the frame rail to secure.
INSTALLING THE GRASS CATCHER (FOR
REAR BAGGING OPERATION)
See Figure 5.
 Remove start key and battery pack.
 Lift the rear discharge door.
 Lift the grass catcher by its handle and place under the
rear discharge door so that the hooks on the grass catcher
are seated onto the slots on the mower housing.
 Release the rear discharge door.
 Reinstall start key and battery pack when you are ready
to mow.
INSTALLING THE MULCHING PLUG
(FOR MULCHING OPERATION)
See Figure 6.
NOTE: When using the mulching plug, do not install the
grass catcher.
 Remove start key and battery packs.
 Lift and hold the rear discharge door.
 Grasp the mulching plug by its handle and insert it at a
slight angle, as shown.
7 — English

Publicité

loading