Mantis Compact ComposTumbler Guide D'assemblage page 14

11.4
Repeat with the second frame leg on the other side.
11.6
Attach the second brace to the first using the ¼ x ¾" hex
head cap screw, lock washer, and nut.
11.8
Use the adjustable and 7/16" wrenches to tighten the
screws and nuts. Note: Remember to tighten the screws
used to connect the struts to the drive assembly in step
11.1.
14
11.5
Place one of the braces onto the screws and fasten it with
lock washers and nuts.
11.7
Rotate the braces toward the drum and fasten them to the
middle holes of the struts as shown below.
Middle Holes
of Strut