Smart Appliance - GE PFWS4605 Manuel D'utilisation Et D'installation

Smart Appliance

Models PFWS4600/5 AND 4400/5 are compatible with
the GE Smart Appliance Module (SAM) which can be
purchased separately. Contact your local utility or visit www.
GEAppliances.com/smart-appliances to see if your area is
using Demand Response (SAM) technology.
INSTALLATION
The preferred location for the module installation is on top of
the clothes dryer.
Details on how to connect the cables to the module are in the
instructions that come with the module.
Wait 5 minutes; then press the Settings button. Scroll and
look for the energy management screen as seen below.
This screen means the module is attached correctly and
you can begin to use your Smart appliance following the
instructions below.
If the Energy Management Screen is not available, refer to
the SAM module troubleshooting guide.
QUICK GUIDE
There are 4 power levels available: Critical, High, Normal and
Low. On the Normal and Low levels, the unit runs as normal.
The following steps show how the unit reacts during startup
at Critical and High power levels.
Option 1 (Delay EP)
During startups at Critical and High levels, the unit will delay
starting until the level becomes Medium or Low. Press the
START/PAUSE button.
Option 2 (Override Delay EP)
When Delay EP is shown, the delay function can be
overridden by pressing the DELAY START button. Pressing the
START/PAUSE key will begin the selected cycle with "e"WASH
enabled. The "e"WASH indicator will be illuminated.
During a Critical Rate period, the Critical Response Mode**
will also be activated to maximize energy savings. EP will be
displayed.
Option 3 (Override "e" WASH)
After overriding the delay function, pressing the "e"WASH
button will disable the "e"WASH setting. Pressing the START/
PAUSE key will begin the selected cycle.
During a Critical Rate period, the Critical Response Mode** will
be activated to maximize energy savings. EP will be displayed.
**Note: The Critical Response Mode can be disabled at any
time by pressing and holding the "e"WASH Button for 3 sec-
onds. EP will be removed from the display
16
SETTINGS MENU
Press SETTINGS; then select Energy Management.
Delay EP Override
This option allows your smart washer to automatically engage
the "e"WASH setting when overriding a Delay EP and starting
a cycle during a Critical or High Rate period. The default
setting is YES.
Auto-Extend Delays
If a timed delay is selected, this option allows for the
scheduled start to extend if the utility rate is Critical or
High at the scheduled start. The default setting will
automatically extend these cycles.
Critical Rate Option
This option allows your smart appliance to respond to Critical
Rate information by automatically engaging the Critical
Response Mode. The Critical Response Mode is designed to
maximize energy savings when a cycle is run during a Critical
Rate period. The default setting is YES. Setting this option to
NO will disable the Critical Response Mode.
In order for the demand response features on the appliance
to work, additional equipment is required to be installed to
interface with the local utility. Such equipment may be sold
separately and/or is available through your utility as part of
the pilot test program. Check with your utility company to
see if a pilot test program is available in your area and for full
details.
PLEASE NOTE: If you move to an area where the program
is not available, the demand response features cannot be
activated and utilized on the appliance. The appliance will
function as normal after the demand response equipment has
been deactivated or disconnected.
GEAppliances.com