IDC Mikro Mode D'emploi page 32

I N S T A L L A T I O N
▷ Insert the selected blank into the holder in the
milling machine. The high/thick side of the blank
E N
must face the inward.
Fig. 7 Inserting a blank
▷ Fasten the blank using four screws and washers.
NOTE:
Do not damage the blank!
▷ Do not overtighten the screws! Avoid mechan-
ical stress!
▷ Tighten the screws with the Allen key provided.
Fig. 8 Tightening a blank
▷ Shut the door of the milling machine.
▷ Switch the milling machine on via the main
switch.
▷ Switch the PC on.
32
▷ Start the milling machine software.
When the software is started, a machine initiali-
sation takes place.
If the milling machine is not detected:
▷ Restart the PC.
After re-positioning the milling machine, it
is necessary to check the system axes.
▷ For this, observe the instructions for
milling the test bodies.