Machine Specifications; Delivery Scope; Intended Use; Ce Declaration Of Conformity - IDC Mikro Mode D'emploi

4

Machine Specifications

4.1

Delivery Scope

_ Milling machine
_ Mains cable
_ USB cable (5 m)
_ Network cable (5 m)
_ Control cable, extraction
_ Compressed-air hoses (250 mm and 2000 mm)
_ Cleaning hose with brush head
_ Maintenance unit
_ Service set for spindle
_ CAM software package
_ Test blank
_ CNC cutter 2.5 (milling tool mounted in collet)
_ Screw set
_ Torque wrench, 4 Nm
_ Blank holder 71
_ Extractor adapter
_ Slide caliper
The milling machine is delivered with a test blank
inserted in the blank holder. Prior to delivery, a
test object was factory-milled in order to check
the zero point settings. Possibly remaining milled
shavings/chips are not a reason for rejection. The
test blank is provided for test milling and calibra-
tion of the milling machine.
▷ After unpacking, check the machine for com-
pleteness and possible transport damages.
Please claim any transport damages immedi-
ately with your supplier.
4.2

Intended Use

The milling machine is a PC-controlled milling ma-
chine for the fabrication of dentures by means of:
_ Dry processing of blanks made of
▪ pre-sintered zirconium oxide
▪ unsintered non-precious metals (NPMs)
▪ wax
▪ plastics
M A C H I N E S P E C I F I C A T I O N S
Using blanks and tools not approved by the manu-
facturer can damage the machine and make the
product unusable. For such cases, the manufac-
turer shall assume no liability whatsoever.
Unauthorised modifications/alterations of the
machine shall also void the warranty.
A compressed-air connection is required
for operation of themilling machine (see
page 29).
Dry processing is permitted only in conjunction
with an appropriate extraction system (for techni-
cal requirements, see page 29).
4.3

CE Declaration of Conformity

In terms of design and performance, this product
complies with the European Directives and the
supplementary national requirements. Conform-
ity has been confirmed with the CE marking.
EU Directives
2006/42/EG
harmonized Standards
DIN EN ISO 12100
DIN EN 61010-1
DIN EN 61000-4-4
DIN EN 61000-4-5
Tab. 3
The product's Declaration of Conformity can be
requested from the manufacturer.
2004/108/EG
DIN EN 13128
DIN EN 55011
E N
25