Cleaning And Maintenance; Cleaning; Maintenance; Weekly Maintenance - IDC Mikro Mode D'emploi

C L E A N I N G A N D M A I N T E N A N C E
7

Cleaning and Maintenance

E N 7.1

Cleaning

The milling machine must be cleaned after each
working day.
NOTE:
Zirconia dust is abrasive!
▷ Clean the window in the door carefully, using
only a soft cloth; do not scrub or scour.
▷ Open the door of the milling machine.
▷ Press operation button [A] on the milling
machine.
The extraction system is activated. The opera-
tion button lights up.
▷ Press service button [B] on the milling machine.
The sealing air at the spindle is activated. The
service button lights up.
▷ Remove the collecting plate.
▷ Vacuum out the milling chamber.
▷ Briefly press service button [B].
The sealing air is deactivated.
▷ Briefly press operation button [A].
The extraction system is deactivated.
36
7.2

Maintenance

7.2.1

Weekly maintenance

NOTE:
Danger of damaging the machine!
▷ Do not use compressed air, ultrasonic or a
steam jet for the cleaning!
Prior to maintenance:
Before maintaining the spindle, the spindle sealing
air must be activated:
▷ Briefly press service button [B].
The current tool is placed down and the spindle
returns to the service position. The spindle is
released; the motor is blocked.
▷ Open the door of the milling machine.
▷ Press service button [B] on the milling machine.
The sealing air is activated. The service button
lights up.
After the maintenance
When the maintenance is completed:
▷ Shut the door of the milling machine.
▷ Briefly push operation button [A].
The tool is picked up again. The spindle travels
back to the starting position or to the position,
where the program was interrupted.
Spindle
The provided spindle service set and a milling tool
of your choice are required for maintenance of
the spindle.
In order to clean the spindle:
▷ Remove any dust from the cap and the spindle
using a dry, soft cloth. Do not use cleaning
agents!