Establishing The Network; Connection; Starting Up The Milling Machine - IDC Mikro Mode D'emploi

5.4 Establishing the Network Connec-
tion
To establish the network connection, the
milling machine and the PC must first be
connected via USB.
▷ Connect the Ethernet interface ([2] in fig. 4) of
the milling machine with the PC or with the net-
work using a network cable.
The maximum permitted length of the network
cable to the PC or to the network router is
100 m.
▷ Switch the milling machine on.
▷ Start the milling machine software.
▷ After initializing the milling machine in the soft-
Settings
ware under >
connection type from USB to Ethernet and
adapt the IP address, if required (see descrip-
tion of the milling machine software).
▷ Switch the milling machine off and then on
again.
▷ Initialize the milling machine in the software.
▷ After the software has detected the Ethernet
connection, remove the USB cable.
When operating via a network, up to eight
milling machines can be connected and
controlled via the CAM Software.
The PC and the milling machine must both
be in the same sub-network.
Communication
, set the
I N S T A L L A T I O N
5.5

Starting up the milling machine

The three standard cutters in tool stations
1-3 are mandatory for operation.
In addition to standard tools, sister tools can
optionally be inserted in the tool holder. When a
standard tool has reached its wear limit, the mill-
ing machine automatically accesses the respec-
tive sister tool.
Fig. 6 Tool holder
▷ Insert the CNC cutter standard tools into the
tool holder of the milling machine. Position the
tool shank facing toward the outside.
▪ CNC cutter 2.5 is in the spindle.
▪ Set CNC cutter 1.0 to position 2.
▪ Set CNC cutter 0.6 to position 3.
▷ Optionally: Insert the sister tools into the tool
holder of the milling machine. Position the tool
shank facing toward the outside.
▪ Set CNC cutter 2.5 to position 4.
▪ Set CNC cutter 1.0 to position 5.
▪ Set CNC cutter 0.6 to position 6.
E N
31