JVC KD-SR82BT Manuel D'instructions page 17

BLUETOOTH®
To
While having two active calls...
End current call and
activate held call
Swap between the
current call and held call
Adjust the phone volume
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes
Improve the voice quality
While talking on the phone....
1 Press and hold .
2
Turn the volume knob to select an item (see the following table), then press
the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
On the faceplate On the remote control
Press and hold
Press and hold or
the volume knob.
( Not available )
Press .
Turn the volume knob ( Not available )
during a call.
• This adjustment will not
affect the volume of the
other sources.
( Not available )
Press during a call.
• Operations may vary
according to the
connected Bluetooth
device.
.
MIC LEVEL –10 — +10 (–4): The sensitivity of the microphone increases
as the number increased.
NOISE RDCT –5 — +5 (0): Adjust the noise reduction level until the least
.
noise is being heard during a phone conversation.
ECHO CANCEL –5 — +5 (0): Adjust the echo cancellation delay time until the
least echo is being heard during a phone conversation.
Make the settings for receiving a call
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step
activated.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 01 SEC — 30 SEC: The unit answers incoming call
automatically in the selected time (in seconds). ;
OFF: Cancels.
RING ILLUMI BLINK 1 — BLINK 5 (BLINK 2): Selects the notification
blinking pattern for the buttons when there is an incoming
call. ; OFF : Cancels.
until the desired item is selected or
ENGLISH
Default: XX
.
Default: XX
13