Specifications; Amplifier Section - Sony TA-N9000ES Mode D'emploi

Specifications

AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 8 ohm loads, both channels driven,
from 20 - 20,000 Hz; rated 120 watts per
channel minimum RMS power, with no
more than 0.03% total harmonic
distortion from 250 milliwatts to rated
output (USA model only).

Amplifier section

POWER OUTPUT
NORMAL mode
(4/8 ohms 20 Hz ~ 20 kHz, THD 0.013%)
Front: 115 W + 115 W
Center: 115 W
Rear: 115 W + 115 W
BTL mode (8 ohms 1 kHz, THD 0.013%)
Front: 200 W + 200 W
Center: 120 W
Speaker Nominal Impedance:
Front, Rear, and Center:
4 to 16 ohms (NORMAL)
8 to 16 ohms (BTL)
Input sensitivity
1 V ±1 dB
Frequency response
20 Hz ~ 20 kHz ±0.2 dB (at 1 W)
10 Hz ~ 100 kHz +0 –3 dB (at 1 W)
Inputs
Input Jack Sensitivity
REAR 1 V
CENTER 1 V
FRONT 1 V
EXTRA 2ch 1 V
16 US
Impedance
45 kilohms
45 kilohms
45 kilohms
45 kilohms
General
System
Pure-complementary High Power Legato
Linear SEPP
Power requirements
120 V AC, 60Hz
Power consumption
4.5 A
17 × 6 × 17
7
Dimensions /
8
including projecting parts and controls
Mass (Approx.)
52 lbs 15 oz (24 kg)
Supplied accessories
Control A1 cable (1)
Design and specifications are subject to change without
notice.
in. (430 × 173.5 × 453 mm)
7
/
8