Entering The Ip Address; Activating/Deactivating The Wifi Function - Seca 651 Mode D'emploi

Entering the IP address

Activating/deactivating the WiFi
NOTE
Manual entry is only necessary if no barcode scanner is connected to
your device. If a barcode scanner is connected, the network connec-
tion can be set up from the
1. Press the
The Settings menu is displayed.
2. Press the
3. Press the Network item.
4. Press the Server address item.
5. Enter the IP address of the server on which the
software is installed:
a) Enter the value
b) Confirm your entry by pressing the
6. You have the following options for continuing:
► Connect the device to the network using a LAN cable
► Establish a WiFi connection ➔
network (seca connect 103), page 98
To activate/deactivate the WiFi function for the device, proceed as follows:
function
1. Press the
The Settings menu is displayed.
2. Press the
Device mode
Basic
Advanced
Expert
Service
seca connect 103
key.
or key until the Network menu item is displayed.
key.
or key until the Network menu item is displayed.
Function available
–
–
•
•
software.
seca connect 103
key
Connecting the device to the WiFi
Configuration • 97
English