Extremis PICNIK Mode D'emploi page 6

ASSEMBLY PROTECTIVE FEET
WHAT YOU NEED
2 people
hex key no. 5
+/- 30 min.
1. Remove the protection caps of the
fastening screws of the 4 feet
indicated on the above drawing
and loosen these screws with a
5 mm Allen wrench.
4. Put some Loctite 270 on the
adjusting screws and tighten the 6
pieces for oormounting with an
Allen wrench number 5 and place
the caps on it again.
6 assembly protective feet + maintenance
To x the protective feet to the
Picnik, all 6 mounted stainless steel
feet must be removed and replaced
by 6 stainless steel feet for delicate
oors PP06 with felt on the bottom.
2. Remove the feet. 3. Replace them by the 6 new feet.
e side with the holes should
always be facing inwards.