Extremis PICNIK Mode D'emploi page 5

ASSEMBLY FLOOR FASTENING HEAVY DUTY
WHAT YOU NEED
2 people
hex key no. 5
+/- 30 min.
1. Remove the protection caps of the
fastening screws of the 4 feet
indicated on the above drawing
and loosen these screws with a
5 mm Allen wrench.
4. Replace them by the 4 new feet.
e side with the holes should
always be facing inwards.
7. Now mark the spots on the ground, as shown on page 16, where you want to anchor the table. Put the Picnik table
aside and drill holes at the indicated spots. Use the xing media most suited to the type of ground on which you
intend to install the Picnik table.
To anchor the Picnik table to the
ground, 4 of the 6 already mounted
stainless steel feet must be removed
and replaced by the 4 stainless steel
feet of the PFLHD04 ground anchor
kit.
2. Remove the feet.
5. Fasten them by means of
countersunk bolts M6 x 25.
3. Insert the spacers in the 4 holes
used for anchoring the table to the
ground.
6. Fix these with nuts M6.
english 5