Extremis PICNIK Mode D'emploi page 4

ASSEMBLY FLOOR FASTENING
WHAT YOU NEED
2 people
hex key no. 5
+/- 30 min.
1. Remove the protection caps of the
fastening screws of the 4 feet
indicated on the above drawing
and loosen these screws with a
5 mm Allen wrench.
4. Put some Loctite 270 on the
adjusting screws and tighten the 4
pieces for oormounting with an
Allen wrench number 5 and place
the caps on it again.
5. Now mark the spots on the ground where you want to anchor the table.
Put the Picnik table aside and drill holes at the indicated spots. Use the
xing media most suited to the type of ground on which you intend to
install the Picnik table.
4 assembly floor fastening + assembly floor fastening heavy duty
To anchor the Picnik table to the
ground, 4 of the 6 already mounted
stainless steel feet must be removed
and replaced by the 4 stainless steel
feet of the PFL04 ground anchor kit.
2. Remove the feet. 3. Replace them by the 4 new feet.
e side with the holes should
always be facing inwards.