Table des Matières
Publicité
Convenient Ways to Use the KC-110
Using a separately available
speaker stand (ST-A95)
By using the KC-110 with the ST-A95 speaker stand (sold separately), it
can be positioned at the ideal height for monitoring or use as a simple
PA system.
Attaching the ST-A95 stand
* You must obtain the assistance of at least one other person when
attaching the KC-110 to the speaker stand, or when adjusting the
height of the speaker stand with the KC-110 attached.
* When setting up, take care not to pinch your fingers.
Stopper
Tripod
1.
Loosen the tripod knob, and open the tripod.
After you've opened the tripod sufficiently, tighten the tripod knob.
* As shown in the illustration below, open the tripod so that its feet
are 98 cm apart. The tripod will be unstable if it is not opened wide
enough.
Diameter:
112 cm or more
(44-1/8")
Leg spread: 98 cm or
more (38-5/8")
2.
Loosen the height adjustment knob, and extend the upper
pipe.
3.
Insert the stopper into the upper tube to obtain the desired
height, up to a maximum height of 145 cm for the stand.
Stopper
* The stopper must be inserted when using the system.
4.
Tighten the height adjustment knob.
5.
Insert the KC-110 onto the upper tube.
Upper tube
Height adjustment Knob
Tripod knob
WARNING
• The KC-110 is designed to be used only in
combination with a Roland-manufactured
speaker stand (ST-A95).
Do not use it with any other stand.
• As shown in the illustration below, adjust
the speaker stand to a height of no more
than 140 cm, and open the tripod to a
spread of 98 cm or more.
• Adjusting the speaker stand to a height
greater than 140 cm or the tripod to a
spread of less than 98 cm may allow the
system to fall over, resulting in damage or
personal injury.
• If you use the KC-110 with a speaker stand, do not place it on an
unstable or tilted location.
You must place the system on a stable, horizontal location.
• Cables connected to the KC-110 should have enough slack, so that
they will not cause an accident if someone trips over them.
• To prevent accidents caused by falling objects, do not place anything
on top of a KC-110 that is mounted on a speaker stand.
Using the KC-110's arm stand
When using the KC-110 at a low position such as on the floor,
extending the arm stand will make the sound from the speakers easier
to hear.
NOTE
• If you use the arm stand, you must place the KC-110 on a horizontal
surface.
• Fold the arm stand if you're not using it.
NOTE
• Do not lift or carry the KC-110 by grasping its arm stand.
• When using the arm stand, do not place objects on the KC-110, or sit
or stand on the KC-110.
• Take care not to pinch your fingers when folding the arm stand.
140 cm or less
(55-1/8")
98 cm or more (38-5/8")
Arm stand
9
Publicité
Table des Matières
