Connecting Wires; Mounting The Sensor - LEGRAND Wattstopper DT-300 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

• Care should be taken to separate high voltage power from low voltage (Class 2) control wiring.

• All connections to sensor are low voltage, Class 2.

Standard wiring with two local off switches

Neutral

White

BZ-200

Black

Hot

Power Pack

**Ground

** BZ-200 Power Pack

must be grounded to

ensure signal integrity,

not for safety ground.

Directly to Ceiling

1. Attach the plastic spring clips to the edge of the sensor in the slots provided.

2. Cut a 3.5" to 4" round hole in the acoustic ceiling tile at the mounting location. A 3.5"

hole is recommended for a secure fit.

3. Pull the low voltage wire from the power pack to the sensor through the hole.

4. Connect the low voltage wires to the appropriate terminals on the sensor.

5. Push the sensor up through the hole until the Spring Clips hold the sensor securely in

place.

6. Snap the front cover onto the sensor.

Using an Octagonal J-Box

1. Pull the low voltage wires from the power pack into the J-Box through the

conduit knockout.

2. Connect the low voltage wires to the appropriate terminals on the sensor.

3. Loosen the appliance mounting screws attached to the J-Box

4. Align the sensor in the J-Box so that the mounting screws on the box match

the key holes on the sensor's rear housing.

5. Push the sensor up into the J -Box and twist it so that the mounting screws are

seated in the keyhole slots.

6. Tighten the two screws to secure the sensor to the J-Box.

7. Snap the front cover onto the sensor.